284 results found (page 5 of 19)
https://www.academia.edu/3145780/TECHNICAL_REPORT_CVEL_06_001_AN_IMPROVED_MODEL_FOR_REPRES…

…50- MHz oscillator) and was loaded with capacitors of different values. A 2-ohm resistor was connected in series with the load capacitor in order to measure the load current. The parasitic inductance of the load interconnect was about 10 nH. The turn-on resistance of the CMOS buf…

https://www.academia.edu/127518745/Rule_Based_Strategy_for_Optimal_Energy_Management_in_Ba…

… Transmis -sion Motor [3] (3) B. Battery model As shown in Fig 3(a), an example resistor and voltage source are used in series to construct a zero-order equivalent circuit model for the battery. Charging voltage and current are calculated as follows [20,19]: Fig. 1.Hybrid powertr…

https://www.academia.edu/23036439/UR_SolarCap_An_Open_Source_Intelligent_Auto_Wakeup_Solar…

…circuit) that amplifies small voltage drops (e.g. < 20 mV) across a small sense resistor to levels in the 1–4 V range that can be measured accurately by the µC’s ADC. The Communication Module comprises of the RS-232 yr and Bluetooth communication interfaces. RS-232 commu- FIGURE …

https://www.academia.edu/80093773/Multi_Layered_Arrays_of_Conducting_Strips_Switchable_Pho…

…photo diodes act as light controllable re- sistors. Let us model the diode by a resistor whose static value is equal to 5 Ω or 10 kΩ. The 5 Ω resistor simulates the direct state of a diode and that of 10 kΩ, the opposite state. These resistive loads were used in a recent experi- …

https://www.academia.edu/127661323/Smart_RFID_label_with_a_printed_multisensor_platform_fo…

…e sensor was connected in a voltage divider configuration with a defined matching resistor (i.e. in the order of MΩ for the ammonia sensor and kΩ for the RTD) to the analog-to-digital converter of the microcontroller. The voltage divider configuration was biased by the microcontroll…

https://www.academia.edu/17645442/Electromagnetic_and_Seismoacoustic_Signals_Revealed_in_K…

…an absolute transducer sensible to 0.5 hPa; the temperature sensor is a thermal resistor sensible to 0.1 ~ In these last two cases the electronic equipment is a bridge-circuit. 22 F. BELLA, P. F. BIAGI, M. CAPUTO, G. DELLA MONICA, ETC. The equipment has three very similar data re…