…" and publish. o Update Auto Configuration ( RFC2462 ) and Neighbor Discovery ( RFC2461 ) and publish. o Investigate approaches to optimize or eliminate Duplicate Address Detection (DAD) to make reduce the delays incurred by DAD when there is a change of network attachment points…

…sis, and integrates nicely with the conceptual model of a host as described in [RFC2461]: a PMTU value could be stored with the corresponding entry in the destination cache. Since Network Address Translators (NATs) and other forms of middle boxes may exhibit differing PMTUs simul…

…-based authorization is particularly suitable for securing neighbor discovery [ RFC2461 ] and duplicate address detection [ RFC2462 ] because these are network-layer signaling protocols for which IPv6 addresses are natural endpoint identifiers. In any protocol that uses other ide…

…s of multicast servers using ND (address resolution) and well-known group IDs [ RFC2461 ]. Consequently, this technique MUST only be used for link scoped multicast addresses. If you want to use multicast addresses greater than link-local scope, you need to use other methods as de…

…s of multicast servers using ND (address resolution) and well-known group IDs [ RFC2461 ]. Consequently, this technique MUST only be used for link scoped multicast addresses. If you want to use multicast addresses greater than link-local scope, you need to use other methods as de…

…UD) and notifying neighbors of changes to link layer addresses. Uses NS and NA [RFC2461]. It should say: * Ensuring that neighbors remain reachable using the same IP and link layer addresses after initial discovery (Neighbor Unreachability Detection - NUD) and notifying neighbors…

… in SMI for the LAST-UPDATED fie 7166(continued): ld, and 7167: +=+=+=+=+= File rfc2461 .txt +=+=+=+=+= 2000 found at line 2347: 2345: consecutive advertisements. 2346: 2347: Default: 2592000 seconds (30 days), 2347(continued): fixed 2348: (i.e., stays the same in consecutiv 2348…

…UD) and notifying neighbors of changes to link layer addresses. Uses NS and NA [RFC2461]. It should say: * Ensuring that neighbors remain reachable using the same IP and link layer addresses after initial discovery (Neighbor Unreachability Detection - NUD) and notifying neighbors…