…ormation Refresh Time Option for DHCPv6 November 2005 1 . Introduction DHCPv6 [ RFC3315 ] specifies stateful autoconfiguration for IPv6 hosts. However, many hosts will use stateless autoconfiguration as specified in [ RFC2462 ] for address assignment, and use DHCPv6 only for othe…
… Previous DHCPv6 Standards The initial specification of DHCPv6 was defined in [ RFC3315 ], and a number of follow-up documents were published over the years: - [ RFC3633 ] ("IPv6 Prefix Options for Dynamic Host Configuration Protocol (DHCP) version 6") - [ RFC3736 ] ("Stateless D…
…ponential backoff algorithm for retransmits that is described in Section 14 of [RFC3315] in order to continuously retransmit the Router Solicitations until a Router Advertisement is received. The hosts SHOULD use the following variables as input to the retransmission algorithm: I…
…m from being used with other address configuration mechanisms, such as DHCPv6 [ RFC3315 ] or manual address configuration. Gont Standards Track [Page 5] RFC 7217 Stable and Opaque IIDs with SLAAC April 2014 4 . Design Goals This document specifies a method for generating Interfac…
…AC, the Router Advertisement would normally signal the availability of DHCPv6 [ RFC3315 ] and the host would use it to configure its addresses. In the latter case (or if both SLAAC and DHCPv6 are used on the same link for some reason), the configured addresses generally match one…
…able. On the other hand, Dynamic Host Configuration Protocol for IPv6 (DHCPv6) [RFC3315] is used when a site requires tighter control over exact address assignments. Both stateless address autoconfiguration and DHCPv6 may be used simultaneously. IPv6 addresses are leased to an in…
…ble. On the other hand, Dynamic Host Configuration Protocol for IPv6 (DHCPv6) [ RFC3315 ] is used when a site requires tighter control over exact address assignments. Both stateless address autoconfiguration and DHCPv6 may be used simultaneously. IPv6 addresses are leased to an i…
…ble. On the other hand, Dynamic Host Configuration Protocol for IPv6 (DHCPv6) [ RFC3315 ] is used when a site requires tighter control over exact address assignments. Both stateless address autoconfiguration and DHCPv6 may be used simultaneously. IPv6 addresses are leased to an i…
…ble. On the other hand, Dynamic Host Configuration Protocol for IPv6 (DHCPv6) [ RFC3315 ] is used when a site requires tighter control over exact address assignments. Both stateless address autoconfiguration and DHCPv6 may be used simultaneously. IPv6 addresses are leased to an i…
…m from being used with other address configuration mechanisms, such as DHCPv6 [ RFC3315 ] or manual address configuration. Gont Standards Track [Page 5] RFC 7217 Stable and Opaque IIDs with SLAAC April 2014 4 . Design Goals This document specifies a method for generating Interfac…
…e in the OPTION_ORO option for DHCPv6 messages as described in Section 22.7 of [RFC3315]. The requesting router SHOULD include the OPTION_PD_EXCLUDE option code in the OPTION_ORO option for DHCPv6 messages as described in Section 22.7 of [RFC3315]. It should say: 6.1. Requesting …
…e in the OPTION_ORO option for DHCPv6 messages as described in Section 22.7 of [RFC3315]. The requesting router SHOULD include the OPTION_PD_EXCLUDE option code in the OPTION_ORO option for DHCPv6 messages as described in Section 22.7 of [RFC3315]. It should say: 6.1. Requesting …