…gation Identifiers (TLAs) and sub-TLAs. The current IPv6 Address Architecture [ RFC3513 ] uses the terminology of Global Identifiers instead of TLAs and sub-TLAs. Huston Informational [Page 1] RFC 4147 IANA IPv6 Registry August 2005 2 . IPv6 Address Registry The proposed format f…

…ation procedure was confirmed with the IETF Chair in March 2010. As stated in [ RFC3513 ], IANA should limit its allocation of IPv6-unicast address space to the range of addresses that start with binary value 001. The rest of the global unicast address space (approximately 85% of…

…dresses. Site-local addresses are defined in the IPv6 addressing architecture [ RFC3513 ], especially in section 2.5.6 . The remainder of this document describes the adverse effects of site-local addresses according to the above definition, and formally deprecates them. Huitema &…

…dresses. Site-local addresses are defined in the IPv6 addressing architecture [ RFC3513 ], especially in section 2.5.6 . The remainder of this document describes the adverse effects of site-local addresses according to the above definition, and formally deprecates them. Huitema &…

…prefix and the rightmost 64 bits of the address form the interface identifier [ RFC3513 ]. We number the bits of the interface identifier starting from bit zero on the left. A cryptographically generated address (CGA) has a security parameter (Sec) that determines its strength ag…

…codings. A host identified by an Internet Protocol literal address, version 6 [ RFC3513 ] or later, is distinguished by enclosing the IP literal within square brackets ("[" and "]"). This is the only place where square bracket characters are allowed in the URI syntax. In anticipa…

…codings. A host identified by an Internet Protocol literal address, version 6 [ RFC3513 ] or later, is distinguished by enclosing the IP literal within square brackets ("[" and "]"). This is the only place where square bracket characters are allowed in the URI syntax. In anticipa…

…encodings. A host identified by an Internet Protocol literal address, version 6 RFC3513 ] or later, is distinguished by enclosing the IP literal within square brackets ("[" and "]"). This is the only place where square bracket characters are allowed in the URI syntax. In anticipa…

…encodings. A host identified by an Internet Protocol literal address, version 6 RFC3513 ] or later, is distinguished by enclosing the IP literal within square brackets ("[" and "]"). This is the only place where square bracket characters are allowed in the URI syntax. In anticipa…

…encodings. A host identified by an Internet Protocol literal address, version 6 RFC3513 ] or later, is distinguished by enclosing the IP literal within square brackets ("[" and "]"). This is the only place where square bracket characters are allowed in the URI syntax. In anticipa…

…encodings. A host identified by an Internet Protocol literal address, version 6 RFC3513 ] or later, is distinguished by enclosing the IP literal within square brackets ("[" and "]"). This is the only place where square bracket characters are allowed in the URI syntax. In anticipa…

…ncodings. A host identified by an Internet Protocol literal address, version 6 [RFC3513] or later, is distinguished by enclosing the IP literal within square brackets ("[" and "]"). This is the only place where square bracket characters are allowed in the URI syntax. In anticipat…

…encodings. A host identified by an Internet Protocol literal address, version 6 RFC3513 ] or later, is distinguished by enclosing the IP literal within square brackets ("[" and "]"). This is the only place where square bracket characters are allowed in the URI syntax. In anticipa…

…encodings. A host identified by an Internet Protocol literal address, version 6 RFC3513 ] or later, is distinguished by enclosing the IP literal within square brackets ("[" and "]"). This is the only place where square bracket characters are allowed in the URI syntax. In anticipa…

…ncodings. A host identified by an Internet Protocol literal address, version 6 [RFC3513] or later, is distinguished by enclosing the IP literal within square brackets ("[" and "]"). This is the only place where square bracket characters are allowed in the URI syntax. In anticipat…