…d using the following sliding window procedure, borrowed from Section 3.4.3 of [RFC4303] . The received record counter for a session MUST be initialized to zero when that session is established. For each received record, the receiver MUST verify that the record contains a sequenc…
… using the following sliding window procedure, borrowed from Section 3.4.3 of [ RFC4303 Because each epoch resets the sequence number space, a separate sliding window is needed for each epoch. The received record counter for an epoch MUST be initialized to zero when that epoch is…
… tunnel mode. However, tunnel-mode IPsec Encapsulating Security Payload (ESP) [ RFC4303 ] should still operate. ¶ 22. IANA Considerations The code points for the STUN methods defined in this specification are listed in Section 17 . IANA has updated the references from [ RFC5766 ]…
…tion-specific API to request that the IP Encapsulating Security Payload (ESP) [ RFC4303 ] be used to provide confidentiality and integrity. Stewart Standards Track [Page 124] RFC 4960 Stream Control Transmission Protocol September 2007 Particularly for mobile users, the requireme…
… tunnel mode. However, tunnel-mode IPsec Encapsulating Security Payload (ESP) [ RFC4303 ] should still operate. 18 . IANA Considerations Since TURN is an extension to STUN [ RFC5389 ], the methods, attributes, and error codes defined in this specification are new methods, attribu…
…sing Extended Sequence Numbers (RFC4304), Encapsulating Security Payload (ESP) (RFC4303), and the algorithms given in the tables below. For configuring IKE, the Legacy Profile uses the following parameters: Parameter Selection RFCs IKE Version IKEv1 RFC2409 Mode Main Mode RFC2409…
… that this is mandated by RFC 4303. Paul / Tero: This is updating the figure in RFC4303 (ESP) and should use "updated IP hdr" instead of "orig IP header", as the specification does in fact modify the protocol, total length and checksum fields. In any potential future document upd…
… that this is mandated by RFC 4303. Paul / Tero: This is updating the figure in RFC4303 (ESP) and should use "updated IP hdr" instead of "orig IP header", as the specification does in fact modify the protocol, total length and checksum fields. In any potential future document upd…