…ting of a minimal-sized HEARTBEAT chunk bundled with a PAD chunk as defined in [RFC4820]. However, RFC 4821 did not provide a complete specification. The present document replaces that description by providing a complete specification. The Datagram Congestion Control Protocol (DC…
…path MTU discovery as specified in [RFC4821], the padding extension defined in [RFC4820] MUST be supported and used for probe packets (HEARTBEAT chunks bundled with PADDING chunks [RFC4820]). 6.3. Dynamic Address Reconfiguration Extension If the dynamic address reconfiguration ex…
…h MTU discovery as specified in [ RFC4821 ], the padding extension defined in [ RFC4820 ] MUST be supported and used for probe packets (HEARTBEAT chunks bundled with PADDING chunks [ RFC4820 ]). 6.3 . Dynamic Address Reconfiguration Extension If the dynamic address reconfiguratio…
…h MTU discovery as specified in [ RFC4821 ], the padding extension defined in [ RFC4820 ] MUST be supported and used for probe packets (HEARTBEAT chunks bundled with PADDING chunks [ RFC4820 ]). 6.3 . Dynamic Address Reconfiguration Extension If the dynamic address reconfiguratio…
…he size of the UDP header. When performing path MTU discovery as described in [ RFC4820 ] and [ RFC4821 ] it MUST be taken into account that one cannot rely on the feedback provided by ICMP or ICMPv6 due to the limitation laid out in Section 4.5 . 4.7 . Handling of Embedded IP-ad…
… chunk consisting only of padding to an SCTP message. The PAD chunk defined in [RFC4820] SHOULD be attached to a minimum length HEARTBEAT (HB) chunk to build a probe packet. This method is fully compatible with all current SCTP implementations. SCTP MAY also probe with a method s…
… or ICMPv6 as specified in [ RFC4821 ] by using probing messages specified in [ RFC4820 ] . The initial Path MTU at the IP layer SHOULD NOT exceed 1200 bytes for IPv4 and 1280 bytes for IPv6. ¶ In general, the lower-layer interface of an SCTP implementation should be adapted to a…
… or ICMPv6 as specified in [ RFC4821 ] by using probing messages specified in [ RFC4820 ] . The initial Path MTU at the IP layer SHOULD NOT exceed 1200 bytes for IPv4 and 1280 bytes for IPv6. ¶ In general, the lower-layer interface of an SCTP implementation should be adapted to a…
…n ICMP or ICMPv6 as specified in RFC4821 by using probing messages specified in RFC4820 The initial Path MTU at the IP layer SHOULD NOT exceed 1200 bytes for IPv4 and 1280 bytes for IPv6. In general, the lower-layer interface of an SCTP implementation should be adapted to address…